SEATING
SEATING
Driver Position Memory System*
The integrated system stores into memory the position of the
driver’s seat, outside rearview mirrors, steering wheel positions
and seat cushion extension* To store positions into memory,
rst place the gear shift into P (Park) while the Engine Start/
Stop button is in the ON position Then:
1 Adjust the driver’s seat, outside rearview mirrors, settings
and steering wheel positions
2 Press the SET button
B
on the control panel System will
beep once
3 Press one of the memory buttons 1 or 2
C
within 4 seconds
The system will beep twice when memory has been stored
(Located on driver’s door control panel)
ALWAYS CHECK THE OWNER’S MANUAL FOR COMPLETE
OPERATING INFORMATION AND SAFETY WARNINGS
†
LEGAL DISCLAIMERS ON BACK INSIDE COVER
*IF EQUIPPED
49
REMINDERS:
• Button may be hard to see if headrest is in its lowest position
• Do not operate the vehicle with the headrests removed Headrests can provide critical
neck and head support in an accident Do not attempt to adjust the seat while the
vehicle is moving This could result in loss of control of the vehicle
See section 3 in the Owner’s Manual for more information
REMINDER: Do not operate the vehicle with the headrests removed Headrests can provide critical neck and head support
in an accident
See section 3 in the Owner’s Manual for more information
To raise headrest: Pull headrest up
To lower headrest: Press the lock button
A
, then press the
headrest down
Front Seat Headrest Adjustment
†11
A
B
C
• For easy adjustments, hold a headrest post
with one hand while using the other hand to
pull the headrest from underneath
QUICK TIP