31
4
4
Features of your vehicle Windows
Power windows
The ENGINE START/STOP button must
be in the ON position for power windows
to operate.
Each door has a power window switch
that controls the door's window. The
driver has a power window lock button
which can block the operation of rear
passenger windows. The power windows
can be operated for approximately 30
seconds after the ENGINE START/STOP
button turned to the ACC or OFF posi
-
tion. However, if the front doors are
opened, the power windows cannot be
operated even within the 30 second
period.
The driver’s door has a master power
window switch that controls all the win
-
dows in the vehicle.
If the window cannot be close because it
is blocked by objects, remove the
objects and close the window.
Whilst driving with the rear windows
down or with the sunroof (if equipped) in
an open (or partially open position), your
vehicle may demonstrate a wind buffet
-
ing or pulsation noise. This noise is a
normal occurrence and can be reduced
or eliminated by taking the following
actions. If the noise occurs with one or
both of the rear windows down, partially
lower both front windows approximately
3 cm (1 inch). If you experience the noise
with the sunroof open, slightly reduce
the size of the sunroof opening.
Do not install any accessories in the area
of windows. It may impact jam protec
-
tion.
Window opening and closing
Type A
To open or close a window, press down
or pull up the front portion of the corre
-
sponding switch to the first detent posi
-
tion (5).
Type B - Auto up/down window
(if equipped)
Pressing or pulling up the power window
switch momentarily to the second detent
position (6) completely lowers or raises
the window even when the switch is
released. To stop the window at the
desired position whilst the window is in
operation, pull up or press down and
release the switch.
To Next Page
Loading...
