Safety features of your vehicle
103
Seat
cushion. Release the switch once the
seat reaches the desired position.
Lumbar support (if equipped)
The lumbar support can be adjusted by
pressing the lumbar support switch on
the side of the seat.
1. Press the front portion (1) of the
switch to increase support, or the rear
portion (2) of the switch, to decrease
support.
2. Release the switch once it reaches the
desired position.
3. Press the upper portion (3) of the
switch to move the support position
up, or press the lower portion (4) of
the switch, to move the support posi
-
tion down.
4. Release the switch once it reaches the
desired position.
Seat back bolster control (if
equipped, for power seat)
1. Turn the adjustment switch clockwise,
the right/left seatback bolsters will be
adjusted inward. Turn the switch
counterclockwise, the seatback bol
-
ster will be adjusted outward.
2. To adjust the bolster height to its
maximum in the default state, operate
the switch for 8 seconds. After that,
release the switch because there is no
change in height even if you continue
to operate the switch.
3. Once adjustment is done, leave the
switch in place.
Driver position memory system (if
equipped, for power seat)
To Next Page
Loading...
