97
5
5
Driving your vehicle Smart Cruise Control (SCC)
僅 If your driving speed is between 0~20
mph (0~30 km/h) when you press the
Driving Assist button, Smart
Cruise Control speed will be set to 20
mph (30 km/h).
僅 The symbol of the Driving Assist but
-
ton can be applied indifferent such as
or depending on the vehi
-
cle.
To set Vehicle Distance
Each time the Vehicle Distance button is
pressed, the Vehicle Distance changes
as follows:
僅 If you drive at 56 mph (90 km/h), the
distance is maintained as follows:
- Distance 4 - approximately 172 ft.
(52.5 m)
- Distance 3 - approximately 130 ft.
(40 m)
- Distance 2 - approximately 106 ft.
(32.5 m)
- Distance 1 - approximately 82 ft. (25
m)
僅 The distance is set to the last set dis
-
tance when the engine is restarted, or
when the function was temporarily
canceled.
To increase speed
僅 Push up the + switch, and release it
immediately. The set speed will
increase by 1 mph (1 km/h) each time
the switch is operated in this manner.
僅 Push up the + switch, and hold it while
monitoring the set speed on the clus
-
ter. The set speed will increase by 5
mph or 10 km/h each time the switch
is operated in this manner. Release
the switch when the desired speed is
shown, and the vehicle will accelerate
to that speed. You can increase the
set speed to 120 mph (200 km/h).
Check the driving condition before using
the + switch. Driving speed may sharply
increase when you push up and hold the
+ switch.
To Next Page
Loading...
