Driving your vehicle
125
ENGINE START/STOP button
and road conditions permit, you may put
the shift lever in the N (Neutral) position
whilst the vehicle is still moving and
press the ENGINE START/STOP button
in an attempt to restart the engine.
僅 If the battery is weak or the smart key
does not work correctly, you can start
the engine by pressing the ENGINE
START/STOP button with the smart
key.
When you press the ENGINE START/
STOP button directly with the smart
key, the smart key should contact the
button at a right angle.
僅 When the stop lamp fuse is blown,
you cannot start the engine normally.
Replace the fuse with a new one. If it
is not possible, you can start the
engine by pressing the ENGINE
START/STOP button for 10 seconds
whilst it is in the ACC position. The
engine can start without pressing the
brake pedal. But for your safety
always press the brake pedal before
starting the engine.
僅 Do not press the ENGINE START/
STOP button for more than 10 sec
-
onds except when the stop lamp fuse
is blown.
僅 Do not turn the ignition switch to the
START position with the engine run
-
ning. It may damage the starter.
Starting the petrol engine
1. Carry the smart key or leave it inside
the vehicle.
2. Make sure the parking brake is firmly
applied.
3.
Manual Transmission
- Depress the
clutch pedal fully and shift the trans
-
mission into Neutral. Keep the clutch
pedal and brake pedal depressed
whilst starting the engine.
If you press the ENGINE START/STOP
button to the START position without
depressing the brake pedal, the
engine will not start, and it will be dis
-
played on the cluster as in the follow
-
ing pop-up.
A:
Press brake pedal before driving
on
When the shift lever is not placed in N
(Neutral), the following pop-up will be
displayed on the cluster.
A:
Shift to neutral for auto start
Dual clutch transmission
- Place the
transmission shift lever in P (Park).
Depress the brake pedal fully.
OAYI044002