Driver assistance system
286
Cruise Control (CC)
Off conditions
Blind-Spot View Monitor will turn off
when one of the following conditions are
satisfied:
僅 When the turn signal is turned off
僅 When the hazard warning flasher is
on
僅 When other important warning is dis
-
played on the instrument cluster
Blind-Spot View Monitor mal
-
function
When Blind-Spot View Monitor is not
working properly, or the cluster display
flickers, or the camera image does not
display normally, have Blind-Spot View
Monitor be inspected by a professional
workshop. Kia recommends visiting an
authorised Kia dealer/service partner.
僅 Blind-Spot View Monitor may display
objects at a different distance from
what is shown on the screen due to
the correction of the wide-side view
camera images. Make sure to directly
check the vehicle's surroundings for
safety.
僅 If the camera lens is covered with for
-
eign material, Blind-Spot View Moni
-
tor may not operate normally.
Always keep the camera lens clean.
However, do not use chemical sol
-
vents such as strong detergents con
-
taining high alkaline or volatile
organic solvents (petrol, acetone etc.).
This may damage the camera lens.
Cruise Control (CC) (if
equipped)
1
Cruise indicator
2
Set speed
Cruise Control will allow you to drive at
speeds above 30 km/h (20 mph) without
depressing the accelerator pedal.
Cruise Control operation
Setting speed
1. Accelerate to the desired speed,
which must be more than 30 km/h
(20 mph).
2. Press the Driving Assist button at the
desired speed. The set speed and
Cruise indicator ( ) will appear
on the cluster.
3. Release the accelerator pedal.
Vehicle speed will maintain the set
speed even when the accelerator
pedal is not depressed.
僅 The vehicle may slightly slow down or
speed up whilst driving uphill or
downhill.
僅 The Driving Assist button symbol may
vary depending on your vehicle
option.
OAYI054076
OAYI054034
To Next Page
Loading...
