Driver assistance system
646
Reverse Parking Collision-Avoidance Assist (PCA)
ing Collision-Avoidance Assist works
normally if you remove the contamina
-
tion from the recognition sensor. Always
keep it clean. If it still does not work
properly even after decontamination is
removed, Kia recommends that you visit
an authorised Kia dealer/service partner.
You can check it in the master warning
mode of the utility information view of
the cluster display window.
Messages displayed on the screen may
differ from the owner's manual due to
the infotainment software version.
Limitations of Reverse Parking
Collision-Avoidance Assist
Parking Collision-Avoidance Assist may
not assist braking or warn the driver
even if there are pedestrians or objects
under the following circumstances:
僅 There is a problem with the vehicle
- Any non-factory equipment or
accessory is installed
- Braking system components, such
as brake discs and calipers, are
modified
- Wheels are misaligned or suspen
-
sion components are modified
- Accessories are attached to the
steering wheel or steering compo
-
nents are modified
- Your vehicle is unstable due to an
accident or other causes
- Bumper height or rear ultrasonic
sensor installation has been modi
-
fied
- If there is severe tilting of the over
-
all height due to abnormal tyre
pressure or excessive loading in the
cargo area
- A snow chain, spare tyre, or wheel
of a different size is installed
- Wide view camera(s) or ultrasonic
sensor(s) is damaged
- Wide view camera(s) or the ultra
-
sonic sensor(s) is stained with for
-
eign material, such as snow, dirt,
etc.
僅 There is a problem with the surround
-
ings
- If there is a pattern on the road
- Shadows on the ground or
reflected light
- Driving through narrow track or
parking spaces
- Pedestrians or objects are near the
path of the vehicle
- Driving through narrow track or
parking spaces
- Driving on uneven surfaces such as
unpaved roads, gravel, road jaws,
ramps, etc
- A trailer or carrier is installed
around the rear corner radar
- Wide view camera(s) is obscured by
a light source or by inclement
weather, such as heavy rain, fog,
snow, etc.
- The surrounding is very bright or
very dark
- Outside temperature is very high or
very low
- The wind is either strong (above 20
km/h (12 mph)) or blowing perpen
-
dicular to the rear bumper
- Objects generating excessive noise,
such as vehicle horns, loud motor
-
cycle vehicles or truck air brakes,
are near your vehicle
To Next Page
Loading...
