EasyManua.ls Logo

Kia Syros 2025 - Page 324

Kia Syros 2025
468 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
15
7
7
What to do in an emergency If you have a flat tyre (with spare tyre)
WARNING
Jack location
To reduce the possibility of injury, be
sure to use only the jack provided with
the vehicle and in the correct jack posi
-
tion; never use any other part of the
vehicle for jack support.
8. Insert the jack handle into the jack
and turn it clockwise, raising the vehi
-
cle until the tyre just clears the
ground. This measurement is approxi
-
mately 30 mm (1.2 inches). Before
removing the wheel lug nuts, make
sure the vehicle is stable and that
there is no chance for movement or
slippage.
9. Loosen the wheel nuts and remove
them with your fingers. Slide the
wheel off the studs and lay it flat so it
cannot roll away. To put the wheel on
the hub, pick up the spare tyre, line up
the holes with the studs and slide the
wheel onto them.
If this is difficult, tip the wheel slightly
and get the top hole in the wheel lined
up with the top stud. Then jiggle the
wheel back and forth until the wheel
can be slid over the other studs.
WARNING
Wheels may have sharp edges. Handle
them carefully to avoid possible severe
injury. Before putting the wheel into
place, be sure that there is nothing on
the hub or wheel (such as mud, tar,
gravel, etc.) that interferes with the
wheel from fitting solidly against the
hub.
If there is, remove it. If there is not good
contact on the mounting surface
between the wheel and hub, the wheel
nuts could come loose and cause the
loss of a wheel. Loss of a wheel may
result in loss of control of the vehicle.
This may cause serious injury or death.
10.To reinstall the wheel, hold it on the
studs, put the wheel nuts on the studs
and tighten them finger tight. Jiggle
the tyre to be sure it is completely
seated, then tighten the nuts as much
as possible with your fingers again.
11.Lower the vehicle to the ground by
turning the wheel nut wrench coun
-
terclockwise.
Then position the wrench as shown in
the drawing and tighten the wheel
nuts. Be sure the socket is seated
completely over the nut. Do not stand
on the wrench handle or use an
OAYI064008_2
OAYI064010

Table of Contents

Related product manuals