Maintenance
668
Light bulbs
Replacing back up lamp (bulb
type)
1. Remove the rear bumper & energy
absorber firmly.
2. Unscrew the reversing lamp hard
-
ware.
3. Disconnect the lamp wiring connector.
4. Remove the reversing lamp from the
rear bumper.
5. Remove the socket from the assembly
by turning the socket counterclock
-
wise until the tabs on the socket align
with the slots on the assembly.
6. Remove the bulb from the socket by
pressing it in and rotating it counter
-
clockwise until the tabs on the bulb
align with the slots in the socket.
7. Pull the bulb out of the socket.
8. Insert a new bulb by inserting it into
the socket and rotating it until it locks
into place.
9. Install the socket in the assembly by
aligning the tabs on the socket with
the slots in the assembly.
10.Push the socket into the assembly
and turn the socket clockwise.
11.Reconnect the lamp wiring connector.
12.Reinstall the light assembly to the rear
bumper.
13.Reinstall the rear bumper to the vehi
-
cle body.
Replacing tail lamp/tail and stop
lamp (LED type) (rear combina
-
tion lamp type B)
If the tail lamp (1) or tail and stop lamp
(2) does not operate, we recommend
that the system be checked by a profes
-
sional workshop. Kia recommends to
visit an authorised Kia dealer/service
partner.
Tail lamp – Type B
Rear combination lamp – Type B
The LED lamps cannot be replaced as a
single component because it is an inte
-
grated unit. The LED lamps have to be
replaced with the unit.
A skilled technician should check or
repair the LED lamps, for it may damage
related parts of the vehicle.
OAYI074050
OAYI074066
OAYI074047
OAYI074051
To Next Page
Loading...
