65
8
8
Maintenance Light bulbs
Replacing side repeater lamp
(LED Type) bulb
If the side repeater lamp LED (1), does
not operate, we recommend that the
system be checked by a professional
workshop. Kia recommends to visit an
authorised Kia dealer/service partner.
Replacing rear turn signal lamp/
tail and stop lamp (bulb type)
Rear combination lamp - Type A
1
Tail and stop lamp
2
Turn signal lamp
To place the lamp bulb:
1. Remove the Rear Bumper firmly.
2. Unscrew the Rear combination lamp
hardware.
3. Disconnect the lamp wiring connector.
4. Remove the rear combination lamp
from the Rear bumper.
5. Remove the socket (1, 2) from the
assembly by turning the socket coun
-
terclockwise until the tabs on the
socket align with the slots on the
assembly.
6. Remove the bulb from the socket by
pressing it in and rotating it counter
-
clockwise until the tabs on the bulb
align with the slots in the socket.
7. Pull the bulb out of the socket.
8. Insert a new bulb by inserting it into
the socket and rotating it until it locks
into place.
9. Install the socket in the assembly by
aligning the tabs on the socket with
the slots in the assembly.
10.Push the socket into the assembly
and turn the socket clockwise.
11.Reconnect the lamp wiring connector.
12.Reinstall the light assembly to the
Rear Bumper.
13.Reinstall the Rear Bumper to the vehi
-
cle body.
OAYI074061
OAYI074065
OAYI074043
To Next Page
Loading...
