Kia Syros 2025 - High-Pressure Washing; Finish Damage Repair

Maintenance
728
Appearance care
僅 To prevent damage to the plastic
parts and lamps, do not clean with
chemical solvents or strong deter
-
gents.
WARNING
After washing the vehicle, test the
brakes whilst driving slowly to see if they
have been affected by water. If braking
performance is impaired, dry the brakes
by applying them lightly whilst maintain
-
ing a slow forward speed.
High-pressure washing
When using high-pressure washers,
make sure to maintain sufficient dis -
tance from the vehicle.
Insufficient clearance or excessive pres -
sure can lead to component damage or
water penetration.
Do not spray the camera, sensors or its
surrounding area directly with a high
pressure washer. Shock applied from
high pressure water may cause the
device to not operate normally.
Do not bring the nozzle tip close to boots
(rubber or plastic covers) or connectors
as they may be damaged if they come
into contact with high pressure water.
CAUTION
Wetting engine compartment
僅 Water washing in the engine compart -
ment including high pressure water
washing may cause the failure of elec -
trical circuits located in the engine
compartment.
僅 Never allow water or other liquids to
come in contact with electrical/elec
-
tronic components and air duct inside
the vehicle as this may damage them.
Waxing
Wax the vehicle when water will no lon -
ger bead on the paint.
Always wash and dry the vehicle before
waxing. Use a good quality liquid or
paste wax, and follow the manufac
-
turer's instructions. Wax all metal trim to
protect it and to maintain its luster.
Removing oil, tar, and similar materials
with a spot remover will usually strip the
wax from the finish. Be sure to re-wax
these areas even if the rest of the vehicle
does not yet need waxing.
Be careful not to touch the lens when
waxing the lamps.
CAUTION
Drying vehicle
僅 Wiping dust or dirt off the body with a
dry cloth will scratch the finish.
僅 Do not use steel wool, abrasive clean
-
ers, acid detergents or strong deter -
gents containing high alkaline or
caustic agents on chrome-plated or
anodized aluminium parts. This may
result in damage to the protective
coating and cause discolouration or
paint deterioration.
Finish damage repair
Deep scratches or stone chips in the
painted surface must be repaired
promptly. Exposed metal will quickly rust
OAYI074060