Kia XCeed 2020 - Page 604

Maintenance Wiper blades
8
54
Foryourconvenience,movethe
windshieldwiperbladestothe
servicepositionasfollows;
Afterturningofftheengine,move
thewiperswitchtothesinglewiping
(MIST)positionwithin20seconds
andholdtheswitchmorethan2
secondsuntilthewiperbladeisin
thefullyupposition.
CAUTION
Donotallowthewiperarmtofall
againstthewindshield,sinceitmay
chiporcrackthewindshield.
1.Raisethewiperarm.
ODEEV098016NR
2.Liftupthewiperbladeclip.Then
pulldownthebladeassemblyand
removeit.
ODEEV098017NR
3.Installthenewbladeassembly.
4.Returnthewiperarmonthe
windshield.
5.TurnignitiontotheONposition
andwiperarmswillreturntothe
normaloperatingposition.
Rear window wiper blade
1.Raisethewiperarmandpullout
thewiperbladeassembly.
OCDW079117
2.Installthenewbladeassemblyby
insertingthecenterpartintothe
slotinthewiperarmuntilitclicks
intoplace.