Wiring Options
Installation
9
Wiring two DS-Series Coax Speakers to a single channel
Modern high performance coaxial speakers have a lower DC Resistance than what used to be available. The Kicker DS-Series
Coax Speakers are rated at four ohms and work with any source unit or amplifier designed to operate at a four ohm load. If you want
to use two DS-Series Coax Speakers on each channel of your source unit or amplifier wire the speakers in series, as shown below.
This will improve the sound quality, lower the total harmonic distortion and lessen the thermal load at the source unit or amplifier. This
may prevent an amplifier from shutting down, due to over-current protection circuitry.
To Next Page
Loading...
