Mounting
This CO alarm can be either wall mounted or
placed on a tabletop.
For wall mounting, follow these steps:
1. Remove back mounting plate from the
alarm, place it in the desired location, and
mark the location of the two holes
needed on the wall.
2. Insert the two screws provided until the
screw heads are protruding approximately
1/8” from the wall. (If mounting
in a plasterboard or drywall, drill
a 3/16” hole in the wall and use
the plastic anchors provided.)
3. Hook the CO alarm over the
screws and onto the keyholes in
the back of the alarm.
Your CO alarm may also be placed
on a tabletop. Simply place in a
location that is easily visible. Be sure
the alarm is no more than three feet
from the floor.
4. Installation Instructions
Wall Mount
Screw Head Distance
from Wall
To Next Page
Loading...
