Page 28
Stratos-Micra • INSTALLER’S HANDBOOK • Iss. 16
6.3 Final installation
Once the power and signal connections are made, slide the detector body up into the
docking station and fasten it into position using the M4 pan head screws provided.
Slot the power and signal terminal blocks into the relevant sockets on the detector
PCB (they will only click fully home in the correct orientation) and replace the detector
cover using the four M3 pan head screws provided.
NB: The detector is designed solely for operation with the front cover securely
fitted using all four fixing screws.
Removing the detector is simply the reverse of this process, leaving the pipe-work and
wiring connections installed in the docking station.
Dock fixing
screws
Cover fixing screws
www.acornfiresecurity.com
www.acornfiresecurity.com
To Next Page
Loading...
