Kidde KN-COPP-3 User Guide

19
Some CO conditions may start out as low level leaks but could develop into CO
concentrations that could become harmful. If this happens, the CO alarm will
detect the dangerous level and alarm, notifying you and others of the condi-
tions. DO NOT ignore high concentration readings above 30 PPM or a CO alarm-
ing device that is in alarm. Refer to page 12 for more details.
CO concentrations displayed below 30 PPM in "Peak Level" memory are for ref-
erence only and the accuracy of the concentration shown may not be as accu-
rate as noted on page 27.
To Reset the Peak Level Memory…
S
S
t
t
e
e
p
p
1
1
.
.
Press the peak level button.
S
S
t
t
e
e
p
p
2
2
.
.
With the peak level button still pressed, press the test/reset button
for two seconds and release.
The number on the display will turn to “0”. The memory has now been
cleared and the alarm will begin monitoring for CO within a few minutes.
Operation

Kidde KN-COPP-3 Specifications

General

Model	KN-COPP-3
Category	Carbon Monoxide Alarm
Power Source	AC Plug-In
Sensor Type	Electrochemical
Test/Reset Button	Yes
Battery Backup	Yes
Audible Alarm	85 dB at 10 feet
Low Battery Signal	Yes
Certifications	UL Listed
Display	Digital
Alarm Type	Audible
Operating Temperature	40°F to 100°F (4°C to 38°C)
Operating Humidity	10% to 95% relative humidity (non-condensing)
Weight	0.5 lbs
Warranty	5-year limited warranty