KidzLabs Tornado Maker

To Next Page

A. SAFETY MESSAGES

. Adult supervisionand assistanceare required at all times.

Thiskit is intended for children 8 years or older.

A WARNING:

CHOKING HAZARD - smallparts

Notfor Childrenunder3 years.

Thiskit and its finished product contain small parts which may causechoking if misused.Keep away from children under 3 years old.

To prevent possible short circuits,nevertouch the contactsinsidethe battery case with any metal.

B. USE OF BATTERIES

Requirestwo I .5V AA batteries (not included).

For best results,always usefresh batteries.

Make sure you insert the batteries with the correct polarities.

Remove the batteries when not in use.

Replaceexhaustedbatteries straight away to avoid possibledamage to the kit.

Rechargeablebatteriesmustbe removed from the kit before recharging.

Rechargeable batteries should be recharged under adult supervision.

Make sure that the supply terminals in the battery case are not short circuited.

Do not attempt to recharge non-rechargeable batteries.

10. Do not mix old and new batteries.

I I. Do not mix alkaline, standard (carbon-zinc), or rechargeable (Ni-Cd) batteries.

C. CONTENTS

Part 1: Base, Part 2: Battery cover, Part 3: Base cover, Part 4: Bottle holder, Part 5: Motor with water-resistant ring installed,

Part 6: Propeller, Part 7: Terminal cap x 2 pcs, Part 8: Screw x 6 pcs, Part 9: Foam ball pack. Also required but not provided: a small

crosshead screwdriver, 1.5V AA battery x 2 and a water bottle.

D. ASSEMBLY

lack

I . Thread the motor wires through the holesin the base cover as shown. Pushthe motor, with the spindle facing up, into the opening of the

base cover. Around the motor spindle there should be a red water-resistantring. The spindle has been treated with water-resistantoil, and

may be slightly greasy.

2. Place the bottle holder over the motor and usetwo screwsto secureit. Be sure to screw them in tight: there should be no gap between

the bottle holder and the base cover.

3. Turn over the base cover so that the ON/OFF switch opening is face-down. Placethe base next to the base cover, with the ON/OFF

switch pointing towards it. Take a wire from the motor and the same coloured wire from the battery case and insert both into one of the

terminal holes next to the switch.Secureboth wires with a terminal cap. Repeatwith the other two wires in the other terminal hole.

QUESTIONS & COMMENTS

We value you as a customerand your satisfactionwith this product is important to us. If you have commentsor questions,or you find

any parts of this kit missingor defective, pleasedo not hesitateto contact our distributor in your country. You will find the addressprinted

on the package. You are also welcome to contact our Marketing Support Team: Email: infodesk@4m-ind.com,Fax (852) 2591 1566,

Tel: (852) 28936241, Web site: WWW.4M-IND.COM

KidzLabs Tornado Maker - User Manual