Kielder KWT-555 - Page 2

3
Kielder WT Ltd KWT-555-IML23
Noise & Vibration Data
Acoustic Pressure: <76 dB(A) K=3dB
Acoustic Power: <85 dB(A) K=3dB
Maximum Vibration: <2.5 m/s2 / K = 1.5m/s2
Sound emission values determined according to
EN62841-1. The declared vibration total value has been
measured in accordance with a standard test method
used to compare one tool with another and according
to EN60745. Both sound and vibration values have an
uncertainty factor of K. The declared total values may
be used in a preliminary assessment of exposure.
WARNING!
The vibration emission during actual
use of the power tool can dier from
the declared total value depending
on the ways in which the tool is used.
The need to identify safety measures and to protect
the operator are based on an estimation of exposure
in the actual conditions of use (taking account of all
parts of the operating cycle, such as the times the tool
is switched o, when it is running idle, in addition to
trigger time). Identify additional safety measures to
protect the operator such as proper maintenance of
the tool, keeping hands warm and organisation of work
patterns.
CONTENTS
Safety Rules & Instruction 4
Product Overview Diagram 8
Specication Table 9
Preparation & Usage
Grease Gun 10
Battery 14
Charging 16
Warranty & Support 18
EC - Declaration Of Conformity
We declare that under our responsibility the
product under part number:
KWT-555 18V Cordless Grease Gun
complies with the applicable EU directives:
2014/35/EU LOW VOLTAGE DIRECTIVE including
the amendments and are manufactured in
accordance following standards or standardised
documents:
EN 60335-1:2012+A11:2014
EN 60335-2-29:2004+A2:2010
EN 62233:2008
EN 55014-1:2006+A2:2011
EN 55014-2:2015
EN 55022:2010+AC:2011
EN 55024:2010
EN 61000-3-2:2014
EN 61000-3-3:2013
All documentation is held in KWT-555 Technical
File and is available, on request for review.
Authorised Signatory:
Steven Bulloss
Director
Dated: 01/12/23
Kielder WT Ltd, Unit C2, Beighton Link
Business Park, Old Colliery Way, Beighton,
Sheeld, S20 1DJ, UK
IMPORTANT!
Please read these operating and
safety instructions carefully and
completely. For your own safety, before using this
equipment check that the voltage is correct and
that all external parts are rmly secured and the
machine in tact. If you are uncertain about any
aspect of using this equipment, or require support
please contact Kielder WT customer services and
we’ll be happy to help:
Tel: 0114 242 3794
Email: tools@kielder.co
Plug Type
• The appliance is supplied with a moulded
three pin mains plug for your safety and
convenience.
• Only use this plug in the socket it is intended.
• A 3 amp fuse is tted in this plug. Should the
fuse need to be replaced please ensure that
the replacement fuse has a 3 amp rating and it
is approved by ASTA or BSI to BS1362.
• Check for the ASTA mark or the BSI mark on
the fuse.
• If the plug contains a removable fuse cover,
you must ensure that it is retted when the
fuse is replaced.
• If you lose the fuse cover the plug must not
be used until a replacement cover is obtained.
Intended Use
The tool is intended for dispensing grease.