6.1
In addition to using
the
front panel, the PLZ-U can
be controlled
remotely using
the
following interfaces.
•
RS-232C interface
•
GPIB interface
The interface is selected from the front panel.
The remote interface accepts
two
formats of commands: IEEE 488.2
common com-
mands and SCPI commands.
Below are the
IEEE
488.2 common commands that
the
PLZ-U supports.
*CLS *ESE
*ESE? *ESR? *IDN?
*OPC *OPC? *RCL
*RST *SAV
*SRE *SRE? *STB? *TRG =^TST?
*WAI
For the detailed list of all SCPI commands, see appendix A.5, “SCPI Command
Reference.”
Please read section
6.3,
“Using SCPI
Commands”
and familiarize yourself with the
SCPI command syntax on the
PLZ-U before actually
using the SCPI
commands.
The
PLZ-U
conforms to the following standards.
•
IEEE Std
488.2-1992
IEEE Standard Codes, Formats, Protocols, and
Common
Commands For Use With IEEE Std 488.
1-1987
•
IEEE Std 488.
1-1987
IEEE Standard
Digital
Interface for
Programmable Instru-
mentation
•
TIA/EIA-232F
•
Standard Commands for Programmable Instruments (SCPI)
version 1999.0
IEEE 488.2 requirements
The GPIB control
conforms
to
all IEEE 488.2 requirements.
SCPI requirements
The GPIB and
RS-232C
controls all conform to the SCPI
requirements. The PLZ-U
conforms
to the
SCPI Volume 4 Power Supply instrument
class.
6-2
Remote
Control PLZ-U