3
Introduction Daily use
KIMAX2
Menu
Configuration
Calibration
Protecting
calibration
Electrical
installation
Sensor
installation
Additional
information
Warranty
Kimax 2 Radio is covered by Sense-Tech Weighing Systems ApS guarantee. Electronic failure
and broken components caused by normal use are repaired or exchanged when necessary,
when sent to the factory.
Damage to your vehicle caused by installation of Kimax instruments or loss of time caused by
recalibration or repairments of Kimax instruments are not covered by Sense-Tech Weighing
Systems ApS in any case.
Basic safety rules
Before you start the installation procedure, make sure that the instruments have not suffered
any damage during transport.
Note that the Kimax 2 instruments must be installed and connected in accordance
with the regulations valid for the vehicle and country in question.
The Kimax 2 instruments must be protected from gravel, water spray from wheels
and other factors that may damage the instruments.
We recommend to mount the instruments in a position where it is protected from
water jets and rinse water.
Once you have decided where the instrument is to be mounted in the cabin, you have to
consider the cable routing.
Special attention should be given to potential damaging factors such as e.g. hinging point for
tilting the cab.
Once you have decided where the instrument is to be mounted on the chassis, you have to
consider the cable routing. Special attention should be given to tensile forces, cuts and other
factors that may damage the cables and hoses.
Connection of compressed air
Before you carry out any installation work related to the air suspension, make sure
that the suspension has been brought to the lowest possible position.
Electrical connection
Always disconnect the battery before you perform any installation work on the
system of the vehicle.
To Next Page
Loading...