30
©2021 Kimberley Kampers Manufacturing Pty Ltd
WiTi Wireless Trailer Plug Connection with built-in Anti-theft & GPS tracking (Optional)
OPERATION GUIDE
WiTi Wireless Towing Interface replaces the traditional cables between a tow vehicle and caravan / trailer
with an advanced wireless connection. WiTi transmits all lighting and braking signals using the latest WiFi
technologies for fast, secure and stable communication. Although wireless, WiTi is not dependant upon
the Internet and communication is point to point between the vehicle unit and trailer unit. The signal is also
encrypted for security and other wireless devices will not interfere with the WiTi Wireless Towing Interface
(mobile phones, bluetooth, wi devices, etc.)
No more cables to damage or rip out, no more corroded terminals and no more loose connections.
Low Power Mode
WiTi Wireless Towing Interface will enter low power mode if there is inactivity for 24 hours. In this mode power
draw is less than 2 milliAmps. WiTi will exit Low Power Mode when it detects an input from the driving light
circuit.
CanBus and vehicles tted with advanced towing features
WiTi Wireless Towing Interface supports all CanBus vehicles and vehicles with advanced electronics. WiTi
supports vehicle speci c towing modes and features for example, disabling reverse sensors when hitched.
These features will be enabled when the WiTi Wireless Towing Interface is in range and paired with the WiTi
Anti Theft unit in the caravan or trailer. Please refer to your vehicle hand book for vehicle speci c towing
modes.
WiTi supports towing modes for:
• Dodge RAM
• Ford vehicles including F Series Trucks
• Isuzu
• Jeep
• Mitsubishi
• Nissan
• Toyota
• VW (Including Amarok and Toureg)
Supported Brake Controllers
WiTi supports all modern electric brake controllers including factory tted units on imported vehicles such as
Ford F Series and Dodge RAM.
If a WiTi Wireless Electric Brake Controller is installed then signals from wired brake controllers (pin 5) will be
ignored.
To Next Page
Loading...