EasyManua.ls Logo

Kimberley KARAVAN 2021 - Page 54

Kimberley KARAVAN 2021
120 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
54
©2021 Kimberley Kampers Manufacturing Pty Ltd
Composting Toilet
Troubleshooting
Fan not working. If using 12 volt battery, check for voltage. Be sure the wire marked positive is attached to the
positive from the battery. Check the fuse. When the fan is running, make sure the fan is blowing outward. If the
fan is still not working, contact Kimberley or your distributor for a replacement.
Compost seems too wet. If too wet due to prolonged diarrhea, add a small amount of sphagnum peat moss.
If wet due to excessive condensation, also add a little sphagnum peat moss. Make sure excessive wetness
is not due to someone urinating directly into the compost section. This can also contribute to an unpleasant
odor. The compost area should have only a musty smell. If a sewage odor is present, please contact Kimberley
for consultation.
Compost seems too dry. If the compost is dry or hard, add some water and turn the agitator after the
sphagnum peat moss has absorbed the moisture.
Cold Conditions. Composting works from 13°C (55°F) and warmer. The warmer it is, the faster it composts.
When the temperature drops to freezing, the compost will be dormant until heat is introduced to the area. Turn
the heater on to raise the temperature in the toilet.
Fruit  ies or gnats. If your toilet incurs  ies or gnats, add  ve cups of natural Diatomaceous Earth to the
compost.
Agitator handle turns with dif culty. If the compost gets dry, the handle may not turn easily. Adding used
coffee grounds results in added moisture and keeps the compost loose so that it mixes better.
Underbody Lighting (where  tted)
Your Kimberley may be  tted with Underbody LED Lighting. This creates
great mood lighting around the campsite. The lighting colour can be
changed and even be set to change in sync with music.
How to use:
1. Download Light Control APP to mobile device - scan QR Code below.
2. Turn power ON at ‘Underbody Lights’ switch (LED light means ON)
3. Pair Lighting APP with Lights and adjust as desired.