Why does my King Canada sander slow down when sanding?
If your King Canada sander slows down while sanding, it might be due to a drive belt that's too tight, or you may be applying too much pressure to the workpiece. Try decreasing the belt tension or easing up on the pressure.
How to fix King Canada KC-703C when the motor will not run?
If the motor of your King Canada sander won't run, it could be due to a defective ON-OFF switch, a defective switch cord, or a defective switch box. Consider replacing these defective parts before using the sander again. Alternatively, the motor might be burned out, in which case it is recommended that a qualified service technician perform the repair.
What to do if wood burns while sanding with King Canada sander?
If wood burns while sanding with your King Canada sander, the sanding disc or belt might be glazed with sap. Replace the disc or belt.
General| Model | KC-703C |
|---|---|
| Type | Belt and Disc Sander |
| Belt Size | 4 in. x 36 in. |
| Motor Power | 3.5 Amps. |
| Dust Collection | Yes |
| Weight | 27 lbs |
| Disc Speed | 3450 RPM |
| Voltage | 120V |
| Disc Diameter | 6 inches |
Keep dated proof of purchase for warranty and servicing purposes.
Replacement parts are available at authorized King Canada service centers across Canada.
Details the 2-year limited warranty, including conditions, exclusions, and claim procedures.
Manual is a guide only; specifications are subject to change without prior notice.
Refer to the King Canada web site for the most updated parts diagram and parts list.
Essential checks and understanding before operation, installation, moving, and pre-operation inspection.
Crucial safety rules for using the tool, handling jams, leaving unattended, and workshop security.
Requirements for connecting the sander, including circuit and fuse/breaker specifications.
Importance and procedure for proper electrical grounding to prevent shock or fire.
Information specific to operating the sander on a 120V power supply.
Guidelines for selecting and using extension cords safely and effectively.
How to operate the switch and utilize the safety key for preventing unauthorized use.
Technical details, dimensions, and weight of the belt and disc sander.
Identification and description of the various components of the sander via a labeled diagram.
Instructions for securely attaching the sander to a workbench or stable surface.
Step-by-step guide for attaching the belt housing to the sander base.
Procedure for installing the drive V-belt and adjusting its tension.
How to install the upper guard for the drive belt and sanding disc.
Instructions for fitting the inner guard for the drive belt assembly.
Guide for mounting the disc and applying the adhesive sanding paper.
Steps to attach the dust collection chute for the sanding disc.
How to install the lower guard for the sanding disc.
Mounting the tilting table and angle pointer for the disc sanding surface.
Attaching the tilting table for the sanding belt to adjust its angle.
How to mount clips for storing accessories like the miter gauge and hex keys.
Techniques and safety precautions for operating the disc sander effectively.
Techniques and safety precautions for operating the belt sander effectively.
How to adjust the belt to ensure it runs centrally on the drive wheels.
Procedure for safely removing and installing a new sanding belt.
Instructions for replacing the adhesive sanding disc on the aluminum disc.
How to check and set the sanding disc table to a precise 90° angle.
Adjusting the sanding belt table for proper alignment and angle settings.
General safety warnings and guidelines for performing maintenance on the sander.
Information on lubricating moving parts for smooth operation.
Checklist of inspections required before operating the sander.
Routine checks and cleaning for optimal performance and longevity.
Common problems encountered with the sander and their corresponding solutions.
To Next Page
