19
Various ways exist to spread the material in the field. One of the simplest
methods is, as follows:
Position spreader at the beginng of the field you intend to fertilize or seed, to a
distance (D/2) that is the half of the working width that is used (point 1);
Driving in the field distributing the fertilizer or seed on all the perimeter;
Stop at one distance (D) from the point 1, equivalent to the set working width
(point 2);
Beginning the spreading proceeding in line, straight to point 3.
Turn and drive a D distance, equal to the working width (point 4);
Repeat such procedure until all the field is covered.
To Next Page