EN
FPCSP41-3
Getting started...
22
Before you start
Assembly
Chain and guide bar
Assemble the guide bar (11) and saw chain (10) before operation.
Use only the guide bar (11) and saw chain (10) according to the technical
parameter of this product.
WARNING! Always use a saw chain designed as “low-kickback” or a
saw chain which meets the low-kickback requirements! A standard saw
chain (a chain which does not have the kickback reducing guard links)
should only be used by an experienced professional operator
Nevertheless, a low-kickback saw chain does not completely eliminate
kickback! A low-kickback or “safety” chain should never be regarded
as complete protection against injury! Therefore always use a low-
kickback saw chain in conjunction with other kickback protection
devices such as the front hand guard!
1. Place the product on a suitable at surface.
2. Loosen the retaining nuts (12) with the multi-tool (31) and remove them
(Fig. 1).
3. Place the slot of the guide bar (11) over the bolts (17). Ensure to t the guide
bar (11) with the saw chain ‘cutter’ symbol at the top of the bar (Fig. 2).
31
12
Fig. 1
17
11
Fig. 2
4. Push the guide bar (11) to the left
towards the drive sprocket (21)
(behind the clutch (20) (Fig. 3)).
11
20
21
Fig. 3
MNL_Petrol Chainsaw_FPCSP41-3_GB_V02_220301.indd 22 3/2/22 11:35 AM
To Next Page
Loading...