EN
FPCSP41-3
Getting started...
Before you start
29
NOTE: Always dispose of lubricant, used oil and objects contaminated
with them in accordance with local regulations.
Checking
NOTE: Perform the following test before operating your product.
This product is equipped with an automatic oiling system! The oiling
system automatically delivers the proper amount of oil to the bar and
chain!
Checking the lubrication requires starting the engine. Before checking,
the product must be fully assembled and all instructions must have
been read.
1. Make sure the guide bar (11) and the saw
chain (10) are in place when you check the
oil delivery.
2. Start the engine; keep it running at medium
power and check if the chain oil is delivered
as shown in the gure (Fig. 18).
Fig. 18
3. Adjust the chain oil adjustment screw (22) of the oiler on the bottom of the
product to adjust the chain oil ow using a supplied screwdriver (32), which is
on the bottom of the product (Fig. 19).
32
22
Fig. 19
MNL_Petrol Chainsaw_FPCSP41-3_GB_V02_220301.indd 29 3/2/22 11:35 AM
To Next Page
Loading...