KINGMAX GT2153 - Adjustment of Needle Timing at Lowest Position; Adjustment of Timing Between Needle and Hook

From the library of Superior Sewing Machine & Supply LLC - www.supsew.com
'
I '
I
i
I
5. ADJUSTMENT OF NEEDLE TIMING AT ITS LOWEST POSITION (Ref. Fig.13)
Remove face
plate and loosen the screw (#209) of needle bar bracket (#206). Turn the hand wheel
(#240} slowly towards you untll the needle bar F (1f707). is aligned wih the screw (#211) of needle
bar crank
rod (#210). This Is considered the lowest position of needle.
6. ADJUSTMENT OF TIMING BETWEEN NEEDLE AND HOOK
(Needle being used is type DP x 17)
1. Turn the zig-zag dial right to the largest width of 10 mm and hav the needle reach at its rightest
. _an? lo'v:'_est P.~.ll)g,
2. Then set the hook so that the end of hook gib comes 0.5 mm right oi needle "L" (Ref. Fig. 14)
3. Turn the hand wheel to the leftest and lowest position. See that the ho ok poing trafels 1 mm above
the thread hole of the needle (Ref. Rg.
15) : · , ;'·_ ·,_ ·
4.
When sew ing the different materials, it Is recorTiri~ended that the timing explained above is a little
delayed.
·.-
. '\.
Needle
Sar (F )
: -\?(/--;\ .. ·
I
...
I
· ; ~~e~le bar
/ cr ank screw
Needle bar
·connecting
link
. (Fig.13)
Needle bar
Needle bar
set sc re w
10
(Fig.14)
Needle
1 m/m
(Flg.15)
Hook point
i
l
i
i
· I
r