12
Method : B Place the atomizer vertically (battery side down) on a paper towel. Drip 10
drops of low or no nicotine e-liquid in the cartridge side and let it sit for several hours
(over night) This can pull old e-liquid out and improve the taste. Perform Method A
before you begin using again.
Method : C Water Flush - Hold under hot running water (cartridge side up) for 30
seconds. Blow in the cartridge side to remove excess water. Alcohol Flush - Fill a squeeze
bottle or empty e-liquid bottle with high proof grain alcohol or vodka. While holding
over a small cup or shot glass, squeeze a generous amount of alcohol into the cartridge
side and allow to ow through. Use the squeeze bottle to suck the alcohol back up or
pour the alcohol back into the squeeze bottle, the alcohol may be reused several times
(do not consume). Blow in the cartridge side to remove excess alcohol. Burn O - Attach
the atomizer to the battery but not the cartridge. While blowing into the cartridge side
press the button on the battery for 10 seconds, you should see vapor coming out near
the button. Continue doing this until no vapor comes out. Smell the cartridge side of the
atomizer (a clean atomizer should have nearly no smell) Repeat Alcohol Flush and Burn
O a maximum of 2 times until no smell is present. Add a 4-5 drops of e-liquid before
using. See our website for a video on this method www.kingpincigs.com/manuals-faqs
To Next Page
Loading...