Kingspan Thermomax HP Series User Manual (English)

Questions and Answers:

M
Molly RiceAug 1, 2025
Why is my Kingspan Thermomax HP Solar panel pump not operating?
- C
  carmstrongAug 1, 2025
  If the Kingspan Solar panel pump is not operating, several issues could be the cause. First, ensure the pump control selector is not in the ‘OFF’ position; if it is, return it to automatic mode ‘AUTO’. Check the wiring at the mains/pump to ensure it's not faulty. Also, a tripped breaker could be the problem, so reset it. Other potential causes include a build-up of limestone around the heat exchanger, in which case you should drain and clean the system thoroughly. If the pump rotor is damaged, refer to the pump manufacturer’s instructions. Note that if the collector temperature is not high enough or the high limit tank temperature has been reached, no action is required.
V
Victoria WilliamsAug 10, 2025
What to do if there is no circulation in my Kingspan Solar panel system?
- C
  Carrie MartinezAug 10, 2025
  If you have no circulation in your Kingspan Solar panel system, consider these potential causes and solutions: * Ensure the pump isolating valves are open. * Check for an air lock at the pressure relief valve; twist the cap to vent air. * Inspect the system for air locks; ensure all pipework rises on the return side and falls on the flow side, and clear any manual vents. * If a non-return valve is jammed, try to free it or replace it. * If the tank high limit has been reached and the system is in stagnation, wait until the system reaches normal operating conditions. * If there is air in the system, re-purge it.
A
Amanda JohnsonAug 20, 2025
How to fix a Kingspan Thermomax HP Solar panel controller that is not operating?
- N
  nthompsonAug 20, 2025
  If the Kingspan Solar panel controller is not operating, start by ensuring the breaker for that circuit is on. If the controller still doesn't work, check the fuse in the controller and replace it with the identical type specified in the controller manual if it's blown. Also, verify if the breaker for that circuit has blown, and reset it if necessary.