KINKI STUDIO
5
CONTROLS
控制
6
5. Control
Power Up
The power inlet IEC of the EX-B7 is located at the rear panel. After the power is supplied to the
amplifier, it will be in Standby state.
There are three LEDs and one Power Button located at the front panel. In Standby state, the middle
LED lit in orange colour. To power up, press on the Power Button once, the soft-starter circuit in the
EX-B7 engaged, after a short delay, the amplifier will be in Operational state with two extreme
ends LED lit in green colour.
The left LED is Ready status and the right LED is Speaker Protection status.
To Next Page
Loading...
