Kinroad 150 - Page 38

KINROAD 150 SERVICE MANUAL VERSION 1, DEC., 2005
39
Remove the return spring stopping plate, and remove the return
spring.
Remove the whole set of starting lever.
Remove the starting idle shaft.
Disassemble the starting spindle.
Disassemble the starting idle shaft.
SPIRAL SPLINE TRANSFERRING STYLE STARTING MECHANISM INSPECTION
Inspect if there is any abrasion or damage of the starting
spindle.
Inspect if there is any abrasion or damage of the starting idle
shaft.
Inspect if there is any abrasion or damage of the starting
spindle bushing and starting idle shaft hole.