ENGLISH
Kinu Grinders LLC assumes no liability for any damage or
injury caused by improper use, or bad repair. All warranty
claims are invalid.
Use the grinder only for its intended purpose (grinding whole,
roasted coffee beans).
BEFORE THE FIRST USE
Unscrew the counter-screw (1) counter-clockwise. Mount the
handle (2) by passing it through the drive hub (3). Then turn
the counter-screw (1) clockwise.
Your coffee grinder is now ready to use.
For the fine adjustment, turn the counter-screw (1) counter-
clockwise (about 2 turns). Turn the adjustment wheel (4)
counter-clockwise, to the desired grinding setting, and then
turn the counter- screw (1) clockwise again. Start with an
initial setting at one and one-half rotations, then adjust to
taste from there. If your coffee grinder grinds too coarse,
repeat the process and turn the adjustment wheel (4)
clockwise. Now your mill should grind finer.
Please make sure that the counter-screw (1) is tightened
every time. If it is too lightly tightened, the grinder can lose
the adjustment setting during the grinding process.
To simplify the operation, hold the grinder at the top and rest
your thumb on the anti-rotational knob (6). Now the grinder
is much more relaxed in your hand and you do not have to
develop such a great compressive force.
Turn the receiver (9) slightly when disengaging from the
grinder
Take a few minutes to read this manual; thus you will avoid
dangers or damage from happening to your coffee grinder.
Thank you for purchasing Kinu M47 Phoenix, you have made
an excellent choice!
Your new grinder is equipped with Black Fusion treated and
hardened conical burrs of - 47 / 32mm and each, with 4 ball
bearings.
It is a high-quality and sturdy coffee grinder, that allows you
to achieve uniform grinding results for all preparation
methods with little effort.
Your coffee grinder has a step-less adjustment with a fine
thread (M10 x 0.5) and 50 subdivisions. For each division, you
adjust the grinding distance by 0.01mm.
4
To Next Page
