10
-16 EX35/40/45/50
EVACUATOR VALVE
Open the evacuator valve once a week
under ordinary conditions - or daily
when used in a dusty place - to get rid
of large particles of dust and dirt.
Check to see if the evacuator valve
is blocked with dust.
NOTE
2) When carbon or oil adheres to the
element, soak the element in de-
tergent for 15 minutes then wash it
several times in water, rinse with
clean water and dry it naturally. Af-
ter element in fully dried, inspect
inside of the element with a light
and check if it is damaged or not.
3. Replace air cleaner element:
Once yearly or after every sixth
cleaning, whichever comes first.
ADJUSTING CLUTCH PEDAL
(MANUAL)
Proper clutch pedal
free travel (A)
20 ~ 30 mm
(0.8 ~ 1.2 in.)
on the pedal
1. Stop the engine and remove the key.
2. Slightly depress the clutch pedal and
measure free travel at top of pedal
stroke.
3. If adjustment is needed, loosen the
lock nut, remove the clevis pin and
adjust the rod length within accept-
able limits.
4. Retighten the lock nut and replace
the clevis pin.
(1) Clutch Rod (A) Free Travel
T46OA30A
The air cleaner uses a dry
element, never apply oil.
Do not run the engine with filter
element removed.
Be sure to refit the cover with
the arrow (on the rear of cover)
upright. If the cover is improp-
erly fitted, evacuator valve will
not function and dust will ad-
here to the element.
(See “Replacing Air Cleaner
Secondary Element” in Every 1
Year maintenance.)
IMPORTANT
To Next Page
Loading...
