7
-6 EX35/40/45/50
To avoid personal injury:
Stop the engine and relieve
pressure before connecting or
disconnecting lines.
Do not use your hand to check
for leaks.
CONNECTING
1. Clean both couplers.
2. Remove dust plugs.
3. Insert the implement coupler to the
tractor hydraulic coupler.
4. Pull the implement coupler slightly
to make sure couplers are firmly
connected.
!!
!!
!
CAUTION
DISCONNECTING
1. First lower the attachment on the
ground to remove the hydraulic pres-
sure in the hose.
2. Clean the couplers.
3. Relieve pressure by moving hydrau-
lic control levers with engine shut off.
Pull the hose straight from the hy-
draulic coupler to release it.
4. Clean oil and dust from the coupler,
then replace the dust plugs.
Your local KIOTI Dealer can sup-
ply parts to adapt couplers to hy-
draulic hoses.
NOTE
COUPLER CONNECTING AND
DISCONNECTING
To Next Page
Loading...
