5
-7
OPERATION
10. TURN THE KEY TO “START” PO-
SITION AND RELEASE WHEN
THE ENGINE STARTS.
1. Be careful not to run the starting
motor longer than 10 seconds due
to its heavy current consumption.
2. If the tractor has not started in 10
seconds stop operating the starter,
wait 30 seconds and then repeat the
starting procedure.
3. Prior to restarting, be sure that the
flywheel is completely stopped.
4. For manual preheating, turn and hold
the key from ON to preheat position.
Only when the brake pedal is en-
gaged with the range shift lever in
neutral position, the motor can be
started(HST).
Only with the shuttle lever in neu-
tral position, the motor can
be started(Manual).
NOTE
11. CHECK TO SEE THAT ALL THE
WARNING LAMPS ON THE IN-
STRUMENT CLUSTER TURN
“OFF”.
(1) Electrical Charge
(2) Parking Brake
(3) Glow Plug Indicator
(4) Engine Oil Pressure
T46O558A
To Next Page
Loading...
