• If a wire harness must contact the end of the bolts or screws or sharp edges and corners, protect
the contact part of the harness with a loom or by winding with electrical insulating tape. If the wire
harness has a grommet, set the grommet securely.
• Take care not to pinch the wire harnesses during installation of a part. If a wire harness has
damaged insulation, repair by winding with electrical insulating tape.
• When using an electrical tester like a volt/ohm meter or clamp on meter, read the manufacturer’s
operating instructions carefully before operating the tester. Be sure that the tester battery is fully
charged and the meter is functioning properly
2.5 Serial number
The generator serial number identifies your particular unit and is important when ordering parts and
accessories. It is also used by your dealer and distributor for warranty administration.
The generator serial number is stamped on the engine block to the right of the oil dipstick. It is also on a
label on both ends of the generator carton as well as the certificate of quality.
8
To Next Page
Loading...
