2. Apply a 0.040~0.059 in (1~1.5 mm) layer of liquid gasket material [1207B or equivalent] evenly on the
sealing face of the crankcase oil tray.
3. Reassemble the crankcase cover in the reverse order of disassembly.
Caution
Make sure to reassemble the crankcase oil tray three minutes after applying the gasket material.
12.3 Crankshaft reinstallation
1. Revolve the crankshaft slowly, placing the timing mark pointing up.
2. Install the valve tappet, move the tappet aside and then reassemble the camshaft. Note that the timing
mark on the camshaft and driving gear should be oriented downward and aligned with the timing mark
on the timing gear.
50
To Next Page
Loading...
