12.4 Crankcase cover assembly
1. Remove any remaining gasket material on the cylinder block and crankcase cover.
2. Apply a 0.040~0.059 in (1~1.5 mm) layer of liquid gasket material [1207B or equivalent] evenly on the
cylinder block sealing face.
3. Reassemble the crankcase cover in the reverse order of disassembly.
Caution
Install the crankcase cover on the cylinder block 3 minutes after applying the gasket material.
4. Screw on the crankcase cover bolts slowly and tighten to the prescribed torque.
12.5 Inspection
● Inspection of the oil alarm
(1) Place the oil alarm in the position shown below. There should be no continuity between the oil alarm
output wire and copper ground wire.
(2) Turn the oil alarm 180° and check again; there should be continuity.
(3) Immerse the oil alarm completely in oil; check the float- there should be no continuity.
Caution: Wait two minutes after immersing the alarm in oil before measuring.
51
To Next Page
Loading...
