■The DC receptacle can be used while the AC power is in use. If you
use both at the same time, be sure not to exceed the total power for
AC and DC.
■Most appliance motors require more than their rated watt-age for
start-up.
AC applications
1. Start the engine and make sure the output indicator light (green) comes on.
2. Confirm that the appliance to be used is switched off, and plug in the appliance.
■ Substantial overloading that continuously lights the over- load
indicator light(red) may damage the generator. Marginal overloading
that temporarily lights the overload indicator light (red) may shorten
the service life of the generator.
■ Be sure that all appliances are in good working order before
connecting them to the generator. If an appliance begins to operate
abnormally, becomes sluggish, or stops suddenly, turn off the
generator engine switch immediately. Then disconnect the
appliance, and examine it for signs of malfunction.
To Next Page
Loading...
