4.Switch on the equipment to be used.
In case of overload operation or when trouble occurs for the equipment being used, the output
indicator light (green) will go out, the overload indicator light(red) will light continuously, and no
power will be put out.
At this time, the engine will not stop, so that the engine must be stopped by setting the respective
engine switch to STOP.
■When equipment requiring a large starting power, like a motor etc.,
is used, the overload indicator light (red) and the output indicator
light(green)may light together for a short time (about 4 sec), but this
is no abnormality. After start of the equipment, the overload indicator
light (red) will go out and the output indicator light (green) will stay lit.
To Next Page
Loading...
