4. STARTING THE GENERATOR
Before starting the engine
Step 1.
Disconnect any leads from the
AC receptacles and DC terminals.
Switch OFF the AC Circuit Breaker.
Step 2.
Turn the fuel tap to ON position.
Step 3.
Pull the choke lever to
CHOKE position.
Step 4.
Turn the engine / starter switch to
the ON position.
Step 5.
Pull the starter grip until resistance
is felt, then pull firmly.
For KGE6500E Electric Start
model, turn key clockwise to START
position and release.
•
Do not allow the starter grip to snap back, Return it slowly by hand.
Step 6.
Move the choke lever to the RUN
position after the engine has started.
•
If the engine stops and will not restart, check the engine oil level and fuel tank level before
further troubleshooting.
9
To Next Page
Loading...
