5. GENERATOR USE
Be sure to ground the generator when the connected equipment is grounded.
•
To prevent an electrical shock from faulty appliances, the generator should be grounded.
Connect a length of heavy cable between the generator's ground terminal and an external
ground source.
•
It is recommended that this generator not be connected for standby power to any household
or building's electrical circuits. Improper connections can allow electrical current from the
generator to back feed into the utility lines. Such back feed may electrocute workers or other
persons who contact the lines during a power outage. When utility power is restored the
generator may explode, burn, or cause fires in the building's electrical system.
•
Do not connect the generator to an automatic transfer device. Severe damage to the generator
may result.
•
The total wattage of all appliances connected must be considered.
•
Do not exceed the current limit specified for any one receptacle.
•
Do not connect the generator to any household circuit. This could cause damage to
the generator or to electrical appliances in the house.
•
Do not modify or use the generator for purposes other than it is intended for.
•
Do not connect an extension to the exhaust pipe.
•
When an extension cable is required, be sure to use a rubber sheathed flexible cable
(IEC 245 or equivalent).
•
Limit length of extension cables to 60m (195 ft) for cables of 1.5mm2 and 100m (325 feet) for
cables of 2.5mm2 . Long extension cables will reduce usable power due to resistance in the
extension cable.
•
Keep the generator away from other electric cables or wires such as commercial power
supply lines.
•
The DC terminals can be used while the AC power is in use. If you use both at the same time,
be sure not to exceed the total power for AC and DC.
•
Most appliance motors require more than their rated wattage for start-up.
10
Ground Terminal
To Next Page
Loading...
