Emission Control System Warranty
Warranty Statement
The U.S. Environmental Protection Agency (EPA) and the California Air Resources Board (CARB) require
manufacturers of small off-road engines to warranty their products with a two year warranty for those components
that are specified as being part of the emission control system. Kipor Power Equipment, EPA, CARB offer the
following explanation of the Emission Control Warranty.
In the United States and California, new small off-road engines must be designed, built, and equipped to meet
stringent emission standards. Kipor must warrant the emission control system on your generator engine for the
periods of time listed below provided there has been no abuse, neglect, improper maintenance, or unauthorized
application of your small off-road engine.
If a warrantable condition is determined, Kipor Power Equipment will repair your small off-road engine at no cost to
you including diagnosis, parts, and labor.
Coverage
Emissions control parts on the engine are warranted for a period of two years, subject to provisions set below. If
any covered part on your engine is defective, the part will be repaired or replaced by Kipor Power Equipment.
Owner’s Responsibilities
You are responsible to maintain the engine as defined in your Kipor Generator Owner’s Manual. Kipor
recommends that you retain all record/receipts covering maintenance on your engine but Kipor Power Equipment
cannot deny warranty claims based on the lack of receipts or for your failure to perform all scheduled maintenance.
You may be denied warranty coverage if a part has failed due to abuse, neglect, improper maintenance, or
unapproved applications.
You are required to bring your generator to an authorized Kipor generator dealer for repairs as soon as a problem
exists. For emissions warranty service, contact your nearest dealer. For a listing, email
service@kiporpowersystems.com or by calling 503-445-0199
Emission Control System Parts
Coverage under this warrany extends only to the emissions control parts listed below:
1. Fuel System
A. Carburetor gaskets
B. Fuel lines, fittings, and clamps
C. Fuel filter (if equipped)
D. Fuel pump (if equipped)
E. Carburetor
2. Intake System
A. Air cleaner assembly
B. Intake manifold
3. Ignition System
A. Ignition coil
B. Spark plug
4. Exhaust System
A. Catalytic converter (if equipped)
B. Exhaust manifold
C. Gaskets
5. Crankcase Breather System
A. Breather assembly
B. Breather tube
6. Air Injection System
A. Secondary air injection valve
7. Fuel Tank Evaporative Emissions Control System
A. Fuel tank
B. Fuel cap
C. Carbon canister and brackets
8. Miscellaneous Items used in above
A. Hoses, connectors, and fittings
B. Electrical switches
To Next Page
Loading...
