9.TROUBLESHOOTING
When the engine will not start:
Is there fuel in the tank?
Refill the fuel tank.
NO
NO
NO
NO
YES
YES
YES
YES
Is the engine switch on?
Turn the engine switch on.
Turn the fuel valve on.
Is the fuel valve on?
Add the recommended oil.
Is the enough oil in the engine?
Is there a spark from the
spark plug?
NO
Replace the
spark plug.
Still on spark
Take the generator
to an authorized
dealer.
Be sure there is no spilled
fuel around the spark plug.
Spilled fuel may ignite.
WARNING
To check:
1) Remove the spark plug cap and clean
any dirt from around the spark plug.
2) Remove the spark plug and install the
spark plug in the plug cap.
3)Set the plug side electrode on the cylin-
der head to ground.
4) Crank the engine, sparks should jump
across the gap.
Clean the fuel filter cup.
NO
Is the fuel reaching the
carburetor?
If the engine still does not
start, take the generator to
an authorized dealer.
-23-
To check:
1) Turn off the fuel valve and lossed the
drain screw.
2) Fuel should flow from the drain when
the fuel valve is turned on.
Drain
plug
Fig. 17 Drain the fuel
8.TRANSPORTING/STORAGE
8.1 When transporting the generator,turn the fuel valve lever OFF and keep the
generator level to prevent fuel spillage. Fuel vapor or spilled fuel may ignite.
8.2 Before storing the unit for an extended period:
1.Be sure the storage area is free of excessive
humidity and dust.
2.Drain the fuel
A. Open the left side maintenance cover.
B. Turn fuel valve lever to ON and then loosen the
carburetor drain screw. Drain the gasoline from the
carburetor and fuel tank into a suitable container.
3. Once a month, recharge the battery.
4. Change the engine oil.
5. Remove the spark plug and pour about a tablespoon of clean engine oil into the
cylinder. Crank the engine several revolutions to distribute the oil, then reinstall
the spark plug.
6. Slowly pull the starter grip until resistance is felt. At this point, the piston is
coming up on its compression stroke and both the intake and exhaust valves are
closed. Storing the engine in this position will help to protect it from internal
corrosion.
-22-
To Next Page
Loading...
