20
19
Scrambler
Press the key programmed as scrambler to prevent any third
party to hear you talking on the phone.
It can be set as: short press: scrambler, long press OFF.
1. Press the programmable key once to open the scrambler mode,
CHANNEL 1 will be shown,
2. Cancel the mode by pressing it again,
CHANNEL 1 will be shown.
Battery volume checking
Display the battery power.
It can be set as: short press: battery power checking, long press
OFF.
1. Press the programmable key once: the battery power will be
shown,
2. Press again: close the display.
Monitoring
Press the programmed as monitor trigger to hold out CTCSS
DCS 2Tone and DTMF signal, and you can hear the signals can not
be heard in normal operation, press the key again to return to normal
operation.
It can be set as: short press: monitor, long press OFF.
1. Press the programmable key once to start monitoring,
Moni Moment ON will be shown,
2. Press again: stop monitoring, Moni Moment OFF will be shown.
Cancel squelch
Press the key, no matter what the signal or carrier wave is (including
optional signal), squelch will be cancelled.
It can be set as: short press: cancel squelch, long press OFF.
1. Press the programmable key once to start squelch constantly,
2. If you do not press it, the squelch will still work.
Emergency Alert
If press the top key programmed as Emergency Alert , you can
give the warning ring according to the programming software, or send
your identity or background music to your companion or the system.
?It can be set as: short press: emergency alert, long press OFF.
1. Press the programmable key once to start alert,
2. Press it again to stop the alert.
Back light
Turn on/OFF the back light.
It can be set as: short press: back light, long press OFF.
1. Press and hold on this key, the back light is on,
2. Release it to recover the normal mode.
Rptr/Talkarnd
When press the key programmed as Rptr/Talkarnd , the next
transmission will be at the same frequency as at which it is received.
It can be set as: short press: Rptr/Talkarnd, long press OFF.
1. Press the key once, Rptr/Talkarnd will be shown,
2. Press to enter,
3. Press / to select the character you need: e.g.:
Repeater Mode or Talkarnd Mode ,
4. Press to confirm.
Instantly select the channel
Shift to the channel you selected instantly, so that you can
communicate at the channel you are used to.
P
2
P
3
P
4
P
4
To Next Page
Loading...
