9 of 12 2008-6-2
M. Press button to return to the previous operation.
9.5 Set Priority Channel
1. Press the “Menu Selection/Enter” button to enter the menu mode.
2. Press
/ button until “PROG LST”.
3. Press
button to select “SCAN LIST”.
4. Press
/ button until “ED PRIO?”.
5. Press
button for selection.
6. Press
/ button until “PRIO#1?” or “PRIO#2?”.
7. Press
button to select the type of the required priority channel.
For example, in Step 7, the type of priority channel is “DES?”. Press
/ button to
select the required priority channel.
8. Press
button to complete operation.
9. Press
button to return to the previous operation.
10. OST
In a certain specific channel, you can revise the QT/DQT encoding setup of current channel.
The operating steps as follows:
A. Press the “OST” button to enter the OST menu mode.
B. Press
/ button until the QT/DQT code/decode shows.
C. Press
button to select quitting.
Note:
¾ Where the OST backup function is selected, the radio will save the OST code of each
channel even if the channel is changed or the machine is shut down.
¾ In the OST state, the LCD of the vehicle mounted radio and P2 icon will display.
¾ In the OST state, press “OST” button again and the QT/DQT of the radio will return to the
original position.
11. GPS Information View
If the radio starts the GPS function, you can view the current GPS information. The specific
operating steps go as follows:
A. Press “GPS Information View” button to enter the GPS information display mode.
B. Press
/ button until the items you require displays.
C. Press
button for selection.
D. Press
/ button for pageup of the following content.
E. Press
button to return to the previous operation.
The specific content can be shown as follows:
1. Positioning star number: “STAR NUM”
2. Longitude “LONGITUD”
3. Latitude “LATITUDE”
4. Altitude “ALTITUDE”
5. Speed “SPEED”
6. Time “TIME”
To Next Page
Loading...
