Kirisun PT8200 - Call Alert

10 of 12 2008-6-2
12. Wired Replication Mode
If the wired replication function is set, the intercom will not quit after entering the wired replication
mode. If it returns to the user mode, the user needs to restart the machine.
The operating steps go as follows:
1 Press [P1] and [P2] buttons for power-on to show “CLONE” (for two seconds) and enter the
replication mode. If such a mode is not allowed, it will enter the user mode.
2 Connect the pickaback plane with the wired replication cable first, and then turn on the power
button for the pickaback plane.
3 Press the host [P4] button for replication. At this time the red host indicator will light and the
data will be transmitted to the pickaback plane from the host. In the period when the pickaback
plane receives the data, it will show “PROGRAM” and the green indicator light. The host will
show “SUCCESS” and the pickaback plane will automatically restart upon receipt of all data.
4 Press the [P4] button and the host will return to the replication mode. Continuous replication
will start from Step 3.
Note: The wired replication mode can be started or prohibited through the PC program software.
Once such a mode is prohibited, the intercom can’t enter the wired replication mode.
13. Common Failures and Troubleshooting
No. Failures Causes and Troubleshooting
1 No reaction after
startup
A The power cable is not joined with the battery or the host reliably. P
l
connect the power cable reliably.
B The protective tube of power cable is burnt out. Please Change it.
C The power button is of poor contact. Please change the silica gel button or
button.
D The battery is out of power. Please charge or change it.
E CPU is broken, Please change IC.
2 Phase lock loop
unlocked
(Beeping)
The crystal X1 of phase lock loop is broken. Please change it.
The oscillator tube is broken. Please change it.
The chip U101 of phase lock loop is broken. Please change IC.
3 No talkback The frequency for talkback is not right. Please re-select the channel of the
s
frequency.
The QT/DQT signaling code for talkback is not the same. Please reset it. P
l
check the setup of receive/send signaling system for both parties.
It is out of the effective communication range.
4 No receiving signal The antenna is not in good contact. Please fasten the antenna head.
The high-frequency amplifying tube Q26 is broken. Please change it.
The squelch level is set high so the squelch can’t be started. Please reset the sq
u
level.
The mixed tube Q21 is broken. Please change it.
The FM chip U101 is broken. Please change IC.