2 of 12 2008-6-2
Stationary Support
Power Cable
Hand Microphone
Microphone Hanger
M4*10 Combination Screw
M5*16 / M4*16 Self-tapping
Screw
１.2 Preparatory Work
1.21 Connection of Power Cable
First of all, please check whether there is a hole for the power cable on the insulating board. If no,
please bore the board with the suitable drill bit and fix a rubber grommet on it.
Afterwards, please have the cable pass through the insulating board and lead from the car into the
car engine. Connect the red conductor to the positive terminal of the accumulator and the black
conductor to the negative terminal.
At last ring the remained conductor and fix it.
Note: Please maintain the sufficient relaxation of the power cable to make it convenient to dismantle
the radio in the state of power connection.
1.22 Fixation of Radio
Warning: For the purpose of passengers’ safety, please fix the radio firmly on the stationary support
so that the radio will not be loosened in case of collision.
1） The stationary support is taken as an example. Draw the position and drill a hole on the
instrument panel first, and then fix the stationary support with 4 M5*16 self-tapping screws.
(Note: please fix the radio at the position convenient for operation and control, and leave an
enough space for fixation and connection of the cable.)
2） Slide the radio into the stationary support and fix it with 4 M4*10 combination screws (plus plain
washer and spring washer). (Different combinations of fixing holes are selectable to adjust the
radio to the proper height and visual angle.)
3） Connect the antenna and the power cable to the radio.
4） Fix the microphone hanger at the position easy to use, with 2 M4*16 self-tapping screws. (The
microphone and its cable should be fixed at the position not affecting safe driving.)
5） Connect the microphone to the microphone jack on the front panel of the radio and put it on the
hanger.
Note: Where replacement of the protective tube for the power cable is required, please use the one
of the same specification without fail. It is not allowed to change it into the tube of higher capacity.
2．Familiarity with the Machine
2.1 Description of External View
To Next Page
Loading...
