8 of 12 2008-6-2
"VOX LEV "
Backlight
"BACK LED"
“BLED OFF"
"BLED ON "
"BL AUTO "
Select among such modes of backlight as
“turnoff”, “normal turn-on” or “auto”.
MCU software version
display
"SOFT VER"
……
Eg．“R01.00”
Show the software version.
9. Scan
In order to receive the calls from many channels, the intercom can be programmed to scan these
channels. At most there are 16 channels in each scan list. Each channel can use a scan list
together with others or alone.
9.1 Start/Close Scan Function
You can press “SCAN” button directly from the menu to activate the scan function. When
the scan function is started, icon and your channel will display at the same time.
In the scan state, the red indicator will flicker. When the scan is stopped, the indicator will
stop flickering.
During the period from the scan state the menu mode, the radio will stop scanning. After
the menu is quitted, the scanning will go on.
2. Enter the scan state through menu mode.
A. Press the “Menu Selection/Enter” button to enter the menu mode.
B. Press
/ button until “SYS SCAN”.
C. Press
button for selection.
D. Press
/ button until “SCAN ON?” or “SCAN OF?”.
E. Press
button for confirmation.
3. Use the scan button.
A. Press “SCAN” button to activate the scan function.
B. Press “SCAN” button again to close the scan function.
9.2Cancel Noise Channel
If a channel continuously produces noise or interference, press the “Mixed Channel (Temporary)
Cancellation” button to cancel this channel from the scan list temporarily.
Note: the priority channel can’t be canceled and the last one in the scan list, either.
Quit the scan mode first, and then re-enter such a mode. If the “Mixed Channel Reset” can work,
the cancelled channel can be added into the scan list.
9.3 Edit Scan List
9.4 Increase or Cancel the Channels in the Scan List
G. Press the “Menu Selection/Enter” button to enter the menu mode.
H. Press
/ button until “PROG LST”.
A. Press
button to select “SCAN LIST”.
I. Press
/ button until “ADD LST?” or DEL LST?”.
J. Press
button for selection.
K. Press
/ button until the channel you want to add or cancel displays.
L. Press
button to complete operation and the show “CHN SAVE” or “CHN DEL”.
To Next Page
Loading...
