40) Only clean and grease the Cardan shaft when the P.T.O. is disengaged, the engine off,
the hand brake engaged and the ignition key removed.
41) Rest the Cardan shaft on its stand when the machine is disconnected.
42) Refit the protective cap on the P.T.O. shaft after having dismantled the Cardan shaft.
43) Lengthy use of the machine can, as a secondary effect, overheat the overdrive and
parts of the hydraulic circuit. Never touch these parts immediately after use as they
are very hot and can cause burns.
44) Never carry out maintenance or cleaning work unless the P.T.O. has been disengaged,
the engine switched off, the hand brake engaged. Periodically check the state and
condition of the protective bars and the protection flap bar.
45) Periodically check that all nuts and bolts are fully fastened. Re-fasten them if
necessary.
46) Always place adequate supports under the implement when servicing the machine or
replacing the hoe blades with the implement raised.
47) Before working on the cutting tools, disengage the P.T.O., switch off the tractor engine,
engage the hand brake and check that the blades are completely at a standstill.
48) Only use the recommended oil.
49) The spare parts must correspond to the requirements established by the
manufacturer. Always use genuine spare parts.
50) The safety transfers must always be perfectly visible. They must be kept clean and
should be replaced if they become illegible. Replacements are available on request
from your local dealer.
51) The instruction manual delivered together with the machine by the dealer must be
kept for as long as the machine lasts.
52) In the event a tractor is used that has no pressurized, soundproof cabin the operator
must use individual methods of protection
53) Protective headphones for noise in case the standard levels of exposure are
exceeded. Anti-dust mask, if a considerable quantity of dust is raised caused by the
type of product cut, by very dusty earth, or by the usage of an open machine.
Attention
SAFETY NOTES
2.0
15
To Next Page
Loading...
